|Problem with run configuration of a product [message #512181]
||Thu, 04 February 2010 10:34
Registered: February 2010
After I configured my RCP product I am testing it via the Link "Launch an Eclipse Application" in the product editor. Up to this moment there is no run configuration existing, after that it is. Thats ok, but now:
- I am going to add a new plug-in dependency to my product.
- Switching to the run configuration an there to the "plug-ins" tab
- Clicking on "Add Required Plug-ins"
--> The new plug-in is not automatically selected. I think it should! Therefor the run won't be successful.
(If I am using the Link "Launch an Eclipse Application" in the product editor again it works fine. )
Is this an intended behaviour or a bug?
Thanks for help
Powered by FUDForum
. Page generated in 0.02050 seconds