|Right Click or Tap'n'Hold Selection in a List [message #467705]
||Fri, 03 February 2006 22:38
| Eddie Atherton
Registered: July 2009
I'm creating a List, that has a Pop-Up menu with a couple of actions.|
When an item is selected with right click (on Windoze) or tap'n'hold
on a PPC, the correct listener is fired, for the Menu. But I haven't
been able to capture any event, either on the List, or the Menu which
lets me identify which item in the List was selected.
I switched to a List, from a Table because of problems with the scroll
bars (see other post), and in Table, before the Menu listener was
invoked, I was able to get the item from a Selection Event on the
Table. But this doesn't seem to happen for a List.
Powered by FUDForum
. Page generated in 0.02935 seconds