Eclipse Community Forums: TMF (Xtext) » Define a limited string consisting out of figures/digits only

Help

Home

Home » Modeling » TMF (Xtext) » Define a limited string consisting out of figures/digits only

Show: Today's Messages :: Show Polls :: Message Navigator

Define a limited string consisting out of figures/digits only [message #1835316]

Mon, 30 November 2020 15:44

Nils K.

Messages: 13
Registered: November 2020

Junior Member

Hello,

I was asked to post the question here.

I want to define a string in my grammar that consists of figures only and is limited in length. In best case I want to verify further rules and if that figure matches a certain type (e.g. matches type long or is within the range of 100 to 2000). How can I do that in xtext?

I thought about something like the following rule, but to be honest I have still issues defining that grammar for all requirements here. Hints? Ideas?

terminal FIGURESTRING returns ecore::EString: '"' ('0'..'9')* '"' | "'" ('0'..'9')* "'";

Report message to a moderator

Re: Define a limited string consisting out of figures/digits only [message #1835318 is a reply to message #1835316]

Mon, 30 November 2020 15:52

Christian Dietrich

Messages: 14566
Registered: July 2009

Senior Member

why not doing this in a semantic validation or value converter.
both will allow you to get much better error messages
than "no viable alt at x" or "expected x but got y"

Twitter : @chrdietrich
Blog : https://www.dietrich-it.de

Report message to a moderator

Re: Define a limited string consisting out of figures/digits only [message #1835322 is a reply to message #1835318]

Mon, 30 November 2020 16:08

Nils K.

Messages: 13
Registered: November 2020

Junior Member

Well, I'm new to xtend so I don't know most of its features yet.

Unfortunately, I'm limited on defining some sort of type, since other parts in the source code of the generator require me to provide it.

Right now, it is working fine with general strings except for the required rules for those numbers that I'd like to add by defining my own string type as shown above.

how can i integrate your mentioned converter in the code line above? I don't see where I am in need of a converter here and just need a simple rule permitting figures with a range for that string only.

[Updated on: Mon, 30 November 2020 16:09]

Report message to a moderator