Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Kura » How to reset WebConsole password
How to reset WebConsole password [message #1829508] Mon, 06 July 2020 02:53 Go to next message
Ken-ichi Fujita is currently offline Ken-ichi FujitaFriend
Messages: 3
Registered: July 2020
Junior Member
Hi all,
I want to reset the password of KURA's Web Console without using KURA's WEB Interface.
Please tell me how to reset the password.
For example, log in to the console with ssh and reset the webconsole.

Regards.
Re: How to reset WebConsole password [message #1829519 is a reply to message #1829508] Mon, 06 July 2020 06:20 Go to previous messageGo to next message
Matteo Maiero is currently offline Matteo MaieroFriend
Messages: 423
Registered: July 2015
Location: Italy
Senior Member
Hi,
the easiest way is to reinstall Kura: the UI access information is stored in Kura snapshot that is encrypted in the filesystem.
Best regards,
Matteo
Re: How to reset WebConsole password [message #1829525 is a reply to message #1829519] Mon, 06 July 2020 07:34 Go to previous messageGo to next message
Ken-ichi Fujita is currently offline Ken-ichi FujitaFriend
Messages: 3
Registered: July 2020
Junior Member
Thank you for your reply.
The information I provided to you was not sufficient.
It is supposed to reset the password of the released gateway device.
I want to reset the password more easily if the gateway user forgets the password.
Therefore, is there any other way than to reinstall KURA?

Regards.
Re: How to reset WebConsole password [message #1829527 is a reply to message #1829525] Mon, 06 July 2020 07:52 Go to previous message
Matteo Maiero is currently offline Matteo MaieroFriend
Messages: 423
Registered: July 2015
Location: Italy
Senior Member
There is currently no recover option for the web UI.
A similar option to reinstallation is to replace all the snapshots with one that is "clean". This will allow you to get again access to the UI but you will loose the previous configurations.
This was done as a security reason to prevent attackers to get access to the device and be able to get the protected information inside the snapshots
Previous Topic:kura build by using maven
Next Topic:WireAsset does not start reading
Goto Forum:
  


Current Time: Sat Dec 14 16:37:06 GMT 2024

Powered by FUDForum. Page generated in 0.03185 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top