Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Polarsys » Capella General » one to many relation in system analysis
one to many relation in system analysis [message #1828325] Sun, 07 June 2020 16:35 Go to next message
Jens Gerlach is currently offline Jens GerlachFriend
Messages: 1
Registered: June 2020
Junior Member

maybe this is a stupid beginner question ...

I have a system that should control and supervise to types of devices: device type A and type B. The system should be able to connect up to 2000 devices. From device type A there must be at least one and a maximum number of 2000 from it. From device B the range is 0 to 2000.
In system analysis level i have two system actors: device type A and device type B.
How can i model the 0 to 2000 or 1 to 2000 relation in system analysis level?

Re: one to many relation in system analysis [message #1828340 is a reply to message #1828325] Mon, 08 June 2020 01:51 Go to previous message
Stephane LACRAMPE is currently offline Stephane LACRAMPEFriend
Messages: 206
Registered: July 2009
Senior Member
I guess using a "constraint" would be appropriated. (look un the palette in the common section)

Obeo Canada
Previous Topic:Modelling phases and stages of a project in capella
Next Topic:Capella problem
Goto Forum:

Current Time: Mon Nov 23 23:36:40 GMT 2020

Powered by FUDForum. Page generated in 0.01547 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top