Eclipse Community Forums: Oomph » Running Oomph setup from the command line

Help

Home

Home » Eclipse Projects » Oomph » Running Oomph setup from the command line

Show: Today's Messages :: Show Polls :: Message Navigator

Running Oomph setup from the command line [message #1814834]

Thu, 19 September 2019 13:14

Lars Vogel

Messages: 1098
Registered: July 2009

Senior Member

Hi,

is it possible to run Oomph profiles for provisioning products and projects from the command line?

Basically, instead of starting the installer, issue a command line to create a new workspace using Oomph

Best regards, Lars

Report message to a moderator

Re: Running Oomph setup from the command line [message #1814837 is a reply to message #1814834]

Thu, 19 September 2019 15:43

Ed Merks

Messages: 33137
Registered: July 2009

Senior Member

Not until someone sponsors such an effort:

https://bugs.eclipse.org/bugs/show_bug.cgi?id=487626

Mostly it could be done with the existing underlying infrastructure using a Configuration that also specifies the installation location (and the workspace location, if the Configuration as a Workspace).

https://wiki.eclipse.org/Eclipse_Oomph_Authoring#Automation_and_Specialization_with_Configurations

Ed Merks
Professional Support: https://www.macromodeling.com/

Report message to a moderator