|AUT connection failed when Cisco VPN is running [message #1802402]
||Fri, 08 February 2019 09:49
| Patrik Hanak
Registered: February 2019
Hello everybody !|
I started to evaluate Jubula to test our application and I am not able to connect to AUT when VPN is running.
I use the following configuration:
OS: MS Windows Server 2012 R2
VPN: Cisco AnyConnect Secure Mobility Client v4.3.01095
Application: Eclipse RCP application, it connects to remote DB over VPN
All test components (AUT, AUT Agent, Jubula GUI client) are installed locally. When I start VPN, run Jubula GUI, open project, connect to embedded AUT Agent and start AUT, then
the application starts but after a while application is closed and error message box appears:
5009: AUT start failed
Establishing connection to AUT failed.
Please check the AUT configuration. AUTServer could not start: Establishing communication failed.
Entry in rc_rcp.log appears as well:
2019-02-08 10:24:38.849 [Worker-0] ERROR o.eclipse.jubula.rc.common.AUTServer - connecting to NAME_OF_SERVER.DOMAIN:50551 failed()
(real name of server and domain were replaced)
After couple of tests I came to the following scenarios which work (Jubula GUI Client is able to connect to AUT):
- VPN is not running (application is temporary reconfigured to connect to local DB )
- the components installed on MS Windows 7, adjusted interface metric of Cisco AnyConnect Adaper
Even if I adjust interface metric of Cisco AnyConnect Adaper ( as it helped on MS Windows 7), it does not help on MS Windows Server 2012 R2.
I can ping NAME_OF_SERVER.DOMAIN, but AUT connection still fails.
Any further ideas ?
Thanks in advance.
Powered by FUDForum
. Page generated in 0.01764 seconds