|
|
|
|
Re: CDT console output - can it be configured to wrap-around ??? [message #1798705 is a reply to message #1798668] |
Fri, 23 November 2018 05:13 |
Ed Merks Messages: 33136 Registered: July 2009 |
Senior Member |
|
|
I replied because I assumed a) that no one will answer your question on this specific forum and b) that CDT probably is using the same Console implementation as JDT so then it would also most likely have a Word Wrap toolbar button.
Is it safe to assume that you've actually checked the toolbar buttons (and menu) in CDT's Console viewer? You might have mentioned mentioned having done so and that you found it to be absent in the case of CDT. Instead you seem more inclined to be snippy; keep in mind that one catches more flies with honey than with vinegar.
Finally, note that CDT has it's own specific forum where someone might answer your question because there the people will be familiar with CDT (and there the question may have been asked before):
https://www.eclipse.org/forums/index.php/f/80/
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.03398 seconds