Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » GMF (Graphical Modeling Framework) » Limiting/changing the anchor points for the connections
Limiting/changing the anchor points for the connections [message #1790720] Thu, 14 June 2018 21:40
Parsa Pourali is currently offline Parsa PouraliFriend
Messages: 210
Registered: February 2014
Senior Member

I was wondering if it is possible to set the anchor point of a connection to some specific points on the source and target figures? For instance, if you look at the image below, the connection is attached to the top side of the figure, however, I want it to only be attached to the middle left and middle right points.


  • Attachment: anchors.png
    (Size: 2.71KB, Downloaded 295 times)
Previous Topic:Eugenia
Next Topic:Programmatically create and open a GMF diagram
Goto Forum:

Current Time: Thu May 23 23:19:39 GMT 2024

Powered by FUDForum. Page generated in 0.03570 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top