|
|
|
Re: Updating AUT to oxygen failed [message #1775046 is a reply to message #1775014] |
Tue, 24 October 2017 07:02 |
Marvin Mueller Messages: 255 Registered: March 2012 |
Senior Member |
|
|
First of all please start your application the first time with -clean, since changes in the plug ins occurred this might re setup the rcp accessor from Jubula
Log files might be helpful, but i doubt it.
Most of the time it is happening that our bundles are not even started. If you have Installation Details dialog in your application this would be the easiest to check if everything from Jubula is in your installation. You can e.g. check if the "org.eclipse.jubula.rc.rcp" has the status "Active". If you have an osgi console you can check this in there.
with regards
Marvin Mueller
[Updated on: Tue, 24 October 2017 07:03] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.04552 seconds