Eclipse Community Forums: 4DIAC - Framework for Distributed Industrial Automation and Control

Home » Eclipse Projects » 4DIAC - Framework for Distributed Industrial Automation and Control » question for the port set of FORTE

Show: Today's Messages :: Show Polls :: Message Navigator

question for the port set of FORTE [message #1773514]

Thu, 28 September 2017 18:14

Fei Yin

Messages: 36
Registered: July 2017

Member

for this sentence in the dokument for the opc ua protocol "To start two FORTE instances on the same PC, you can pass the port on the command line, e.g., ./forte -c localhost:61500" i don't know how can i set the port for FORTE. It says that i kann pass the port on the command line. But where can i give the command line? what is the definite command? Are you so kind to tell me?

Thank you in advance
Fei Yin

Report message to a moderator

Previous Topic:	Current state of Modbus support
Next Topic:	question for the port set of FORTE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Tue Apr 23 11:23:33 GMT 2024

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter