|
|
|
|
|
|
|
|
Re: Targlet / P2Task requirement filter with oomph variable [message #1860880 is a reply to message #1860870] |
Thu, 07 September 2023 06:31 |
Ed Merks Messages: 33258 Registered: July 2009 |
Senior Member |
|
|
Profile properties have a specific purpose. I don't think it's appropriate to just dump all variables into the profile. Just have a look at the Outline view when you have a Setup open and see the very large number of variables that are in scope. Also, variables aren't prompted unless they are actually used so such usage analysis would then need to consider if some filter from some requirement is intended to refer to a variable or not to know whether that variable requires promoting. I don't see that specifying the profileProperties attribute is all that onerous to justify building additional specialized infrastructure to make it less onerous.
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.06549 seconds