Eclipse Community Forums: Compare » Problem with merging multiplicity-many eOpposites

Help

Home

Home » Modeling » Compare » Problem with merging multiplicity-many eOpposites

Show: Today's Messages :: Show Polls :: Message Navigator

Problem with merging multiplicity-many eOpposites [message #1749158]

Fri, 02 December 2016 12:47

Vlad Acretoaie

Messages: 95
Registered: April 2014

Member

Hi,

I am trying to resolve a merge conflict involving a multiplicity-many eOpposite reference. I would expect this to work out-of-the-box, since it seems that this case is implemented by the default equivalence engine (DefaultEquiEngine). However, the merge does not seem to work as expected.

Here are some details.

I have two classes (A and B), referring to each other by references A.b(1) and B.a(*). These references are eOpposites and non-containment. I then create a conflicting change on A.b. After resolving the conflict on A.b, I can see that the B.a reference is not updated.

Is this a known limitation of the DefaultEquiEngine? If so, do you have any suggestions for overcoming it?

Thanks in advance!

Vlad

Report message to a moderator

Re: Problem with merging multiplicity-many eOpposites [message #1749165 is a reply to message #1749158]

Fri, 02 December 2016 14:18

Vlad Acretoaie

Messages: 95
Registered: April 2014

Member

Hi again,

After investigating a bit more, I think the root cause of my problem goes a little further. I am executing model merging twice, and it seems that the second time there is some information missing.

I will very likely open a new forum thread for this, but as of now it looks like the DefaultEquiEngine actually works as it should.

If possible, this thread should be deleted.

Cheers,
Vlad

Report message to a moderator