Eclipse Community Forums: Jubula » Problem to run basic test on RCP

Help

Home

Home » Archived » Jubula » Problem to run basic test on RCP(Jubula setup issue with RCP)

Show: Today's Messages :: Show Polls :: Message Navigator

Problem to run basic test on RCP [message #1743413]

Thu, 15 September 2016 08:34

Jim 20100

Messages: 69
Registered: June 2016

Member

Hello,

I have created my own Eclipse product.

In my eclipse IDE I have a product file from which I have exported my Eclipse application.
in my product configuration, I have selected:
Product: org.eclipse.platform.ide
Application: org.eclipse.ui.ide.workbench

I don't know if I can consider this as an RCP application but I think yes.

So I installed the jubula plugins in my Eclipse IDE.
I followed the tutorial to add the needed plugins to my product.
+ I set the start command in the config.ini

I installed the standalone Jubula.
I added my AUT as an RCP AUT and I am able to start it correctly.

I created a simple Test case to select the File menu.
When I start my testing, nothing happens, then a timeout.
It seems it cannot connect to AUT?

I need urgent help to progress on my testing phase.

Regards
Jim

Report message to a moderator

Re: Problem to run basic test on RCP [message #1743449 is a reply to message #1743413]

Thu, 15 September 2016 14:06

Alexandra Schladebeck

Messages: 1613
Registered: July 2009

Senior Member

Hi Jim,

If I'm correct, we just had some email contact and your problem was solved - is that the case?
(Apologies if not, but it sounds like the same problem Smile