|
|
|
Re: [EMF Forms] Master Detail View invisible/does not show up [message #1734102 is a reply to message #1733210] |
Fri, 03 June 2016 19:49 |
Gerd Wütherich Messages: 12 Registered: July 2009 |
Junior Member |
|
|
Hi Ram, hi Eugen
thanks for the replies. I think I already tried this before I posted to this forum, but I'm not sure .
However, I tried this now, but after adding the above-mentioned bundles to the launch configuration the application start fails immediately (unfortunately without any meaningful message). Again, removing the master-detail-view from the viewmodel fixes the problems, the other controls seem to work as expected.
After debugging a bit deeper to find the possible cause I discovered that the application starts fails due to an SWTError (org.eclipse.swt.SWTError: No more handles). You can catch the exception by setting a breakpoint at org.eclipse.e4.core.internal.di.MethodRequestor (line:65).
Should I open a bug report for this? Or is it an already known bug?
Again, thanks for your feedback!
Regards,
Gerd
[Updated on: Fri, 03 June 2016 19:50] Report message to a moderator
|
|
|
|
Powered by
FUDForum. Page generated in 0.03092 seconds