Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » OM2M » OM2M using COAP Protocol(How to configure COAP binding in to eclipse IN-CSE and MN-CSE stack)
OM2M using COAP Protocol [message #1733048] Tue, 24 May 2016 05:03 Go to next message
Nithyananth Sivasubramanian is currently offline Nithyananth SivasubramanianFriend
Messages: 5
Registered: May 2016
Junior Member
Hi,

I have gone through the basic eclipse OM2M tutorial and followed
the steps defined in the eclipse website and downloaded the IN-CSE and
MN-CSE stack and configured as per tutorial instruction. I have made
the bellow setup.
IN-CSE--- PC1
MN-CSE--PC2
Now i have started the IN-CSE and MN-CSE , MN-CSE configured
successfully on IN-CSE then i started sample programme. I can able to
control the sample program from PC1 then i captured the packet using
wireshark . Now i can see only http packet but i need to replace this
http protocol with COAP. Please help me how to configure the
configuration file so that i can able to control my remote devices
using COAP protocol and also how to link COAP binding in existing plugin.


Regards
Nithyananth

[Updated on: Tue, 24 May 2016 05:03]

Report message to a moderator

Re: OM2M using COAP Protocol [message #1740623 is a reply to message #1733048] Tue, 16 August 2016 12:17 Go to previous message
Son Duong is currently offline Son DuongFriend
Messages: 60
Registered: June 2016
Member
hi Nithyananth,
were you successfully in using the coap binding? If yes, can you give me a hint how to use it. Thank you so much!

Regards,
Son
Previous Topic:Does OM2M support oneM2M Release 2 (i.e. Semantics)?
Next Topic:Add a new plugin in OM2M (without Eclipse)
Goto Forum:
  


Current Time: Fri Mar 29 12:30:12 GMT 2024

Powered by FUDForum. Page generated in 0.05381 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top