|
Re: COAP [message #1732876 is a reply to message #1732813] |
Sat, 21 May 2016 13:54 |
Ed Merks Messages: 33140 Registered: July 2009 |
Senior Member |
|
|
It's best to ask on their specific forum:
http://www.eclipse.org/forums/eclipse.om2m
On 20.05.2016 18:15, Nithyananth Sivasubramanian wrote:
> Hi Eclipse,
>
> I have gone through the basic eclipse OneM2M tutorial and followed
> the steps defined in the eclipse website and downloaded the IN-CSE and
> MN-CSE stack and configured as per tutorial instruction. I have made
> the bellow setup.
> IN-CSE--- PC1
> MN-CSE--PC2
> Now i have started the IN-CSE and MN-CSE , MN-CSE configured
> successfully on IN-CSE then i started sample programme. I can able to
> control the sample program from PC1 then i captured the packet using
> wireshark . Now i can see only http packet but i need to replace this
> http protocol with COAP. Please help me how to configure the
> configuration file so that i can able to control my remote devices
> using COAP protocol and also how to link COAP binding in existing plugin.
>
>
> Regards
> Nithyananth
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.08593 seconds