Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Newcomers » Newcomers » COAP(Request to help how to edit IN-CSE and MN-CSE stack to make default COAP protocol instead of http )
COAP [message #1732813] Fri, 20 May 2016 11:56 Go to next message
Nithyananth Sivasubramanian is currently offline Nithyananth SivasubramanianFriend
Messages: 5
Registered: May 2016
Junior Member
Hi Eclipse,

I have gone through the basic eclipse OneM2M tutorial and followed the steps defined in the eclipse website and downloaded the IN-CSE and MN-CSE stack and configured as per tutorial instruction. I have made the bellow setup.
IN-CSE--- PC1
MN-CSE--PC2
Now i have started the IN-CSE and MN-CSE , MN-CSE configured successfully on IN-CSE then i started sample programme. I can able to control the sample program from PC1 then i captured the packet using wireshark . Now i can see only http packet but i need to replace this http protocol with COAP. Please help me how to configure the configuration file so that i can able to control my remote devices using COAP protocol and also how to link COAP binding in existing plugin.


Regards
Nithyananth
Re: COAP [message #1732876 is a reply to message #1732813] Sat, 21 May 2016 13:54 Go to previous message
Ed Merks is currently offline Ed MerksFriend
Messages: 30551
Registered: July 2009
Senior Member
It's best to ask on their specific forum:

http://www.eclipse.org/forums/eclipse.om2m


On 20.05.2016 18:15, Nithyananth Sivasubramanian wrote:
> Hi Eclipse,
>
> I have gone through the basic eclipse OneM2M tutorial and followed
> the steps defined in the eclipse website and downloaded the IN-CSE and
> MN-CSE stack and configured as per tutorial instruction. I have made
> the bellow setup.
> IN-CSE--- PC1
> MN-CSE--PC2
> Now i have started the IN-CSE and MN-CSE , MN-CSE configured
> successfully on IN-CSE then i started sample programme. I can able to
> control the sample program from PC1 then i captured the packet using
> wireshark . Now i can see only http packet but i need to replace this
> http protocol with COAP. Please help me how to configure the
> configuration file so that i can able to control my remote devices
> using COAP protocol and also how to link COAP binding in existing plugin.
>
>
> Regards
> Nithyananth
Previous Topic:Mac-specific: Enable Character Picker
Next Topic:Error activating bundle org.eclipse.core.resources (83)
Goto Forum:
  


Current Time: Sun Oct 20 17:52:35 GMT 2019

Powered by FUDForum. Page generated in 0.03596 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top