Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » UML Profiles and SysML FlowPorts(About Using the Flowports of SysML)
UML Profiles and SysML FlowPorts [message #1722640] Sun, 07 February 2016 18:03 Go to next message
Muhammad Kashif is currently offline Muhammad KashifFriend
Messages: 52
Registered: April 2015
Member
Hello,

I am developing a UML profile, I want to use SysML's Flowports and there is n metaclass of "flowports" because in UML there is no such thing as flowports but ports only (without direction).

Is there any way that I can use flowports at profile level. The main purpose to use flow ports is because of their direction..

Please help me out in this problem..

Thanks in advance
Re: UML Profiles and SysML FlowPorts [message #1722677 is a reply to message #1722640] Mon, 08 February 2016 09:01 Go to previous messageGo to next message
Camille Letavernier is currently offline Camille LetavernierFriend
Messages: 935
Registered: February 2011
Senior Member
Hi,

Profiles only support a subset of UML. Basically, everything that is in the Papyrus Profile Diagram palette. Anything else won't be supported (Or might be accidentally, partially supported...)

A Profile is similar to a Metamodel, in this sense that it only supports few, core concepts (Stereotype, Properties, Associations, Generalization and various data types, etc.). If you need more advanced concepts from UML or SysML, you're probably misunderstanding the notion of Profiles. Maybe a UML Library (Model) would be more fit for your usage? Or even a mix of a Profile and a Library

Regards,
Camille


Camille Letavernier
Re: UML Profiles and SysML FlowPorts [message #1722713 is a reply to message #1722677] Mon, 08 February 2016 14:06 Go to previous message
Muhammad Kashif is currently offline Muhammad KashifFriend
Messages: 52
Registered: April 2015
Member
Thanks for the response..

So there is no way to use flowports at profile level..

Actually I want to provide flowports in profile, Is it possibe that I give only port and the in model flowport stereotype can be applied to that port to make it work like a flowport..?

Or any other alternative??

Thanks in advance
Previous Topic:Change font for association ends
Next Topic:Any type of Feature is allowed for Slots
Goto Forum:
  


Current Time: Wed Mar 03 15:37:16 GMT 2021

Powered by FUDForum. Page generated in 0.02628 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top