Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Archived » Jubula » Jubula confusing controls if they have same technical names(Jubula confuses mapped controls if they have assigned same technical names)
icon4.gif  Jubula confusing controls if they have same technical names [message #1679399] Mon, 16 March 2015 15:52 Go to next message
Irfan Khaliq is currently offline Irfan KhaliqFriend
Messages: 4
Registered: March 2015
Junior Member
Take an example of toolbar buttons.

If we have a view (or even different views) that have two toolbar buttons and "IF" after mapping those components, both of those get same "technical names" like, org.eclipse.swt.widgets.ToolItem_1, then Jubula confuses these components in test cases even if we have assigned them different names while mapping.

For example, checking for one toolbar button (actually not present) would be confused by the other toolbar button if it was present there.

Same is applicable to other controls like labels.

Did any one else notice this behavior of Jubula?
Re: Jubula confusing controls if they have same technical names [message #1684088 is a reply to message #1679399] Wed, 18 March 2015 09:28 Go to previous message
Alexandra Schladebeck is currently offline Alexandra SchladebeckFriend
Messages: 1613
Registered: July 2009
Senior Member
I saw that you put a ticket in for this - thank you!
Previous Topic:Getting daily errors in the Jubula Configuration error log
Next Topic:QEMU Emulator launch fails with Jubula on Linux host
Goto Forum:

Current Time: Sun Apr 14 14:17:12 GMT 2024

Powered by FUDForum. Page generated in 0.09325 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top