Eclipse Community Forums: EMF » Figure view different from Figure Gallery (during run-time)

Home » Modeling » EMF » Figure view different from Figure Gallery (during run-time)(Ellipse Figure in Gmfgraph but different Figure view during run-time )

Show: Today's Messages :: Show Polls :: Message Navigator

Figure view different from Figure Gallery (during run-time) [message #1670968]

Fri, 13 March 2015 12:07

Basheer Jasser

Messages: 23
Registered: September 2014
Location: University Putra Malaysia...

Junior Member

I'm setting a figure descriptor as ellipse in Figure gallery, but after generating the diagram code, the node (which is configured with this ellipse figure) is appearing as rectangle as it has been set differently in gmfgraph.

any advices or tips why the figure view in the diagram code is appearing differently from what it is meant to be as ellipse ??

Thanks in advance

Report message to a moderator

Re: Figure view different from Figure Gallery (during run-time) [message #1671137 is a reply to message #1670968]

Fri, 13 March 2015 13:26

Ed Merks

Messages: 33137
Registered: July 2009

Senior Member

It sounds like you intended to post this to the GMF forum.

On 13/03/2015 1:07 PM, Basheer Jasser wrote:
> I'm setting a figure descriptor as ellipse in Figure gallery, but
> after generating the diagram code, the node (which is configured with
> this ellipse figure) is appearing as rectangle as it has been set
> differently in gmfgraph.
>
> any advices or tips why the figure view in the diagram code is
> appearing differently from what it is meant to be as ellipse ??
>
> Thanks in advance

Ed Merks
Professional Support: https://www.macromodeling.com/

Report message to a moderator