Skip to main content


Eclipse Community Forums

      Home
Home » Modeling » Papyrus » How to display ExecutionEnvironment content from Deployment Diagrams ?
How to display ExecutionEnvironment content from Deployment Diagrams ? [message #1148007] Mon, 21 October 2013 03:37 Go to next message
Eclipse UserFriend
Hello,

I have migrated from Papyrus 0.9.2.v201302131112 to Papyrus 0.10.1.v201309181302 but I can no longer display the execution environement content to show the artifacts which are deployed on them.

There's any solution ?


Configuration:

  • Eclipse: 4.3.0.M20130911-1000 (Kelper SR1)
  • Papyrus: 0.10.1.v201309181302
Re: How to display ExecutionEnvironment content from Deployment Diagrams ? [message #1148014 is a reply to message #1148007] Mon, 21 October 2013 03:42 Go to previous message
Eclipse UserFriend
After some tries, the problem appears only if I display the execution environment as device content. I have DnD the execution environment directly on diagram, there's no problem.

[Updated on: Mon, 21 October 2013 03:42] by Moderator

Previous Topic:Unable to remove diagram
Next Topic:Own property tabs & sections for own Metamodel
Goto Forum:
  


Current Time: Sat Jul 19 13:15:33 EDT 2025

Powered by FUDForum. Page generated in 0.05850 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top

Sign up to our Newsletter

A fresh new issue delivered monthly