Debug - Callstack updated but no jump to breakpoint [message #1509565] |
Sat, 13 December 2014 10:09 |
Karsten Bidstrup Messages: 1 Registered: December 2014 |
Junior Member |
|
|
Hi
I am using Eclipse Luna with a plugin from IAR to debug an arm application build with the IAR Embedded Workbench. (Also tried with Keppler with the same issue)
The project is setup as Makefile project.
Everything is basically working except for one problem.
When debugging and running to breakpoint the call stack is automatically updated but Eclipse does not jump to the source/dissasembly. If I click in the call stack to go to the current address THEN Eclipse goes to the correct source/dissasembly.
This happens every time and it seems
I am not sure if this a problem with Eclipse (maybe some missing setting) or if the problem is with the plugin.
I am hoping someone here migth have an idea to what can cause this problem.
|
|
|
Powered by
FUDForum. Page generated in 0.01823 seconds