|Re: How to create link and node at the same time [message #209191 is a reply to message #209176]
||Wed, 22 October 2008 14:16
Originally posted by: tobk42.gmx.de|
For starters, you can use the ModellingAssistantProvider for creating a
Link together with its target node. There you can determine the possible
source and target element types for a given link, so the editor will
ask you which target node to create when drawing a link in "empty
space". If there's only one target element possible, the node will be
create right away.
Alas, I do not know how to create a link from the palette if there's not
even the source node present... :-(
Patrick Tessier schrieb:
> I would like to create a set of node and link between them, thanks to the
> For the moment, I can only create each element element, but I don't know how
> and where I can create this composition of creation.
> For example for link I think I have to put position for target anchor and
> source anchor.
Powered by FUDForum
. Page generated in 0.02605 seconds