GMFGEN: List Layout = false property restricts the area available for connection in a Node ? [message #164949] |
Mon, 10 December 2007 20:08 |
Eclipse User |
|
|
|
Originally posted by: marcio.debarros.gmail.com
Hi,
I posted a message with a similar content earlier but since then, got
new information...
I have a Node/Rectangle figure with a label inside it. This figure has a
compartment associated to it, where I can add another objects, which are
not relevant to the connection.
My connection is only between the outside rectangles. Once I have two
rectangles, and try to create a connection between them using my
connection tool, the only place where I can drag the connection out, is
at the label area, on the top of the rectangle.
It appears that this behavior is caused by setting the "List Layout"
property to false for a compartment in the gmfgen file. If I set it to
true, I can use the whole figure for connection, but all my child nodes
becomes listed inside. I tried adding a Layout (Flow) to the rectangle
but with no success.
Has anyone experienced this before and found a solution ?
Thanks,
--MD.
|
|
|
Powered by
FUDForum. Page generated in 0.02532 seconds