Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Requirements Modeling Framework  » Getting orphaned SpecObject back?
Getting orphaned SpecObject back? [message #1073307] Wed, 24 July 2013 13:48 Go to next message
Jerry Bastian is currently offline Jerry BastianFriend
Messages: 2
Registered: July 2013
Junior Member
Hello again,

I have looked around, but am unable to find out how to "un-orphan" a SpecObject. I can see it under the SpecObjects in the Outline view, but I cannot figure out how to get it back into the specifications. I have tried drag and drop, cut and paste, copy and paste all without success. The target specification in both the editor and the outline view will not accept a drop or paste. Is there a way to do this?

Thank you.
Re: Getting orphaned SpecObject back? [message #1073309 is a reply to message #1073307] Wed, 24 July 2013 13:54 Go to previous message
Michael Jastram is currently offline Michael JastramFriend
Messages: 235
Registered: April 2010
Location: Düsseldorf, Germany
Senior Member
Hi Jerry,

Drop and Drag used to work, if it doesn't you found a bug. Would be great if you could file it in Bugzilla - I'll try to get this into 0.8.0, due mid August.

For the time being, here is a workaround:

  1. Create an empty SpecHierarchy
  2. Select it
  3. In the Properties View, switch to "All Attributes"
  4. In "Object" you can select an existing SpecObject from the drop-down.


- Michael
Previous Topic:Easier selection?
Next Topic:RMF/ProR 0.8.0 released
Goto Forum:

Current Time: Thu Nov 30 22:05:17 GMT 2023

Powered by FUDForum. Page generated in 0.02277 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top