|
|
|
| Re: What happened to auto-profile update? [message #1021159 is a reply to message #1021066] |
Tue, 19 March 2013 15:25   |
 Ed Willink
Messages: 7655
Registered: July 2009 |
Senior Member |
|
|
Hi
It seems no different in the 19-March 0.10 N-build. (I'm using an M6(a)
EMF).
The pop-up appears when saving the profile but niot when loading its
coinsumer.
The Refresh icon is greyed out, but the profile can be manually applied
(again).
Regards
Ed
On 19/03/2013 13:12, Camille Letavernier wrote:
> Ed,
>
> I have the expected behavior in the latest build. The dialog pops up
> when the profile has been redefined. If you don't want to update again
> now, you can also use the "Refresh" button in the profile tab, which
> re-applies the selected profile(s).
>
> With M6 approaching, the current nightly builds can be really
> unstable, depending on what components you update. We have noticed
> non-trivial changes in Junit, EMF and CDO.
>
> Regards,
> Camille
|
|
|
| Re: What happened to auto-profile update? [message #1021309 is a reply to message #1021159] |
Tue, 19 March 2013 21:13 |
Camille Letavernier
Messages: 952
Registered: February 2011 |
Senior Member |
|
|
Ed,
The dialog appears when the profile has been reapplied and reloaded (i.e. you have to reopen the diagram on which the profile is applied for the dialog to open).
If the dialog doesn't appear and the refresh button is disabled, then the profile definition has not changed. Maybe the profile definition actually failed when you defined the profile?
I'm also using the latest M6 builds (Actually, the ones published in releases/staging, which means at least one aggregation build needs to run before I can update), and the Papyrus nightly builds. I will check that properly tomorrow, when building Papyrus M6.
Camille
Camille Letavernier
|
|
|
Powered by
FUDForum. Page generated in 0.03333 seconds
] 
Search
Help
Register
Login
Home
