Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » GMF (Graphical Modeling Framework) » Figure Overlapping Problem
Figure Overlapping Problem [message #103684] Wed, 14 February 2007 10:20 Go to next message
sandip is currently offline sandipFriend
Messages: 54
Registered: July 2009
Member
Can anyone plz elaborate on the following? I didnt find
SetConstraintsCommand anywhere.

Q: How can I prevent my figures in the editor to overlap?
A: This topic was already discussed but there are two possibilities:
constrain node location on move (adjust location in SetConstraintsCommand or
add vetoing command from another edit policy when location is bad) or do
special layout after each diagram modification that will relocate
overlapping figures. You could do the both to ensure that your nodes never
overlap - even when location is altered from another editor.
Re: Figure Overlapping Problem [message #696484 is a reply to message #103684] Thu, 14 July 2011 05:16 Go to previous message
bunta Choudhary is currently offline bunta ChoudharyFriend
Messages: 38
Registered: December 2010
Member
Sandip , sorry to reopen this topic but did you get the solution for the same or any sample.
Previous Topic:Dynamic Figure at runtime
Next Topic:is there any video tutorial on how to model with GMF?
Goto Forum:
  


Current Time: Wed Mar 03 09:29:13 GMT 2021

Powered by FUDForum. Page generated in 0.01764 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top