| 'Open Declaration' Source Code Tunnel Vision... Blah! [message #90692] |
Fri, 29 July 2005 20:24  |
Eclipse User |
|
|
|
Originally posted by: aen.verge-rpg.com
Whenever I click on a link in a stack trace in the console, or do Open
Declaration for an identifier, it takes me to the source file I want,
but it only shows me the lines of a single method if the identifier was
a method, or even a single line if it was a member declaration -- this
drives me insane. I have to close out the file and reopen it, then go
down to the line i want, since most of the time I want to see the code
AROUND where I went, or potentially modify it.
I can't figure out how to toggle this off. Help!
|
|
|
|
| Re: 'Open Declaration' Source Code Tunnel Vision... Blah! [message #91232 is a reply to message #90692] |
Mon, 01 August 2005 11:05  |
| Eclipse User |
|
|
|
Originally posted by: eclipse3.rizzoweb.com
Charles Rector wrote:
> Whenever I click on a link in a stack trace in the console, or do Open
> Declaration for an identifier, it takes me to the source file I want,
> but it only shows me the lines of a single method if the identifier was
> a method, or even a single line if it was a member declaration -- this
> drives me insane. I have to close out the file and reopen it, then go
> down to the line i want, since most of the time I want to see the code
> AROUND where I went, or potentially modify it.
>
> I can't figure out how to toggle this off. Help!
See http://eclipsewiki.editme.com/JavaEditor#showOnlySelectedIte m
HTH,
Eric
|
|
|
Powered by
FUDForum. Page generated in 0.10298 seconds
Home