Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Graphiti » manhattan-like freeform-connection ??
manhattan-like freeform-connection ?? [message #757062] Wed, 16 November 2011 09:59 Go to next message
Christian Waniek is currently offline Christian WaniekFriend
Messages: 50
Registered: May 2010
Hi everybody,

I have the requirement to have a rectingular connection layout (like Manhattan-Connections), but it has to possible to add additional bendpoints and to move EVERY bendpoint, as it is possible with Freeform-Connections.
In the end connections should behave e.g. like connections in the Ecore Diagram Editor of the ecore tools.

Any ideas are highly appreciated.

Thanks in advance to everybody.

Re: manhattan-like freeform-connection ?? [message #757073 is a reply to message #757062] Wed, 16 November 2011 11:31 Go to previous message
Hernan Gonzalez is currently offline Hernan GonzalezFriend
Messages: 188
Registered: October 2010
Location: Buenos Aires, Argentina
Senior Member
Please search in the forum before asking, this (practically) same question was asked yesterday.

In short, you can't.

[Updated on: Wed, 16 November 2011 11:31]

Report message to a moderator

Previous Topic:Graphiti Connections
Next Topic:Setting of Diagram in the Diagram editor
Goto Forum:

Current Time: Fri Aug 07 18:33:12 GMT 2020

Powered by FUDForum. Page generated in 0.01913 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top