|
Re: Xtext 1.0 compatible with Xtext 1.0.1? [message #629380 is a reply to message #629376] |
Tue, 28 September 2010 05:52 |
Sebastian Zarnekow Messages: 3118 Registered: July 2009 |
Senior Member |
|
|
Hi Samantha,
Xtext 1.0.1 should be fully backwards compatible to Xtext 1.0 without
any regeneration necessary. What kind of problems do you face with
content assist?
What kind of support for RHEL6 do you have in mind?
Regards,
Sebastian
--
Need professional support for Eclipse Modeling?
Go visit: http://xtext.itemis.com
Am 28.09.10 06:21, schrieb Samantha Chan:
> Hello,
>
> Firstly, thank you for all your help with my previous posts. It was very
> helpful.
>
> Now, I am wondering what your compatibility statement for XText 1.0 and
> Xtext 1.0.1. I have just installed XText 1.0.1. I tried running an
> editor that was generated on XText 1.0 with XText 1.0.1 and have noticed
> regressions. I have not tested it extensively, but noticed problems with
> content assist. I have not digged deep to figure out what's wrong, but I
> am wondering what the general compatibility statement is. Do you expect
> the generated editors will be forward compatible? i.e. do I have to
> regen every time a new version of XText comes out?
>
> In addition, I am also wondering if you have any plans on supporting Red
> Hat Enterprise Linux 6 when it becomes available. And when do you think
> you can support it? Do you foresee any problems with supporting RHEL 6?
>
> Thanks once again for all the help.
> Samantha
>
>
|
|
|
Powered by
FUDForum. Page generated in 0.02652 seconds