|EMF.edit commands [message #622843]
||Fri, 06 July 2007 02:48
| Bogdan Pistol
Registered: July 2009
I have a few things not very clear about the edit commands.
I'm using an AdapterFactoryEditingDomain with commands in a
BasicCommandStack. I tested successfully the ChangeCommand (it modifies the
model and undo/redo works).
Is there a reason I should use SetCommand, or AddCommand or other commands?
I could make the same "set" and "add" with model changes inside a ChangeCommand.
What is the difference between the two approaches?
Powered by FUDForum
. Page generated in 0.01785 seconds