Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » Work with diagram
Work with diagram [message #581927] Fri, 06 March 2009 07:58
Kirill is currently offline KirillFriend
Messages: 5
Registered: July 2009
Junior Member
Hi!

I've downloaded papyrus source from here:
http://dev.eclipse.org/svnroot/modeling/org.eclipse.mdt.papy rus

I want use this source as a base for my UML Editor. But I've some question:
1. When model opened all diagrams exist as tabs in edtior. How can I show
only one diagram in editor?

2. How can I open diagram in editor? I tried use
SashDiagramModelUtil.openDiagram(diagram.eResource(), diagram);

but I got IllegalStateException.

3. How can I make RCP application? (same as Papyrus-1.11.0)

Thank you very much.
Previous Topic:Integrate GMF into Papyrus
Next Topic:State Diagram
Goto Forum:
  


Current Time: Tue Jan 21 19:49:12 GMT 2020

Powered by FUDForum. Page generated in 0.01555 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top