Eclipse Community Forums: Papyrus » Dragging existing SysML blocks into block definition diagrams doesn't work

Help

Home

Home » Modeling » Papyrus » Dragging existing SysML blocks into block definition diagrams doesn't work

Show: Today's Messages :: Show Polls :: Message Navigator

Dragging existing SysML blocks into block definition diagrams doesn't work [message #558791]

Tue, 14 September 2010 13:23

Markus Lorenz

Messages: 11
Registered: August 2010

Junior Member

Hey guys,

I'm not sure if this is a bug or if I'm missing something.

I have some existing SysML blocks which I use in an internal block diagram. Now I want to use the same blocks in a block definition diagram. I tried dragging them from the Model Explorer into the diagram, but the dropping is not allowed.

What works is creating new blocks directly into the diagram by selecting "Block" from the Palette. But when I remove them I can never put them back into the diagram again.

Dragging existing blocks from the Model Explorer into block definition diagrams is not working. It's no problem with internal block diagrams, though.

Any ideas?

Regards,

Markus

Report message to a moderator

Re: Dragging existing SysML blocks into block definition diagrams doesn't work [message #558987 is a reply to message #558791]

Wed, 15 September 2010 08:55

Raphael Faudou

Messages: 105
Registered: July 2009

Senior Member

Hi Markus,
Looks like a bug as you should definitively be able to drag and drop
blocks from model explorer in a BDD.
Can you please open a bug in the bugzilla?
thanks
raphaël

Le 14/09/2010 15:23, Markus Lorenz a écrit :
> Hey guys,
>
> I'm not sure if this is a bug or if I'm missing something.
>
> I have some existing SysML blocks which I use in an internal block
> diagram. Now I want to use the same blocks in a block definition
> diagram. I tried dragging them from the Model Explorer into the diagram,
> but the dropping is not allowed.
>
> What works is creating new blocks directly into the diagram by selecting
> "Block" from the Palette. But when I remove them I can never put them
> back into the diagram again.
>
> Dragging existing blocks from the Model Explorer into block definition
> diagrams is not working. It's no problem with internal block diagrams,
> though.
>
> Any ideas?
>
> Regards,
>
> Markus

Report message to a moderator