|
Re: image size in Birt 2.5.2 [message #534615 is a reply to message #534471] |
Wed, 19 May 2010 16:06 |
|
Take a look at the fit to container property in the advanced settings.
This will determine if the image is clipped or scaled. You will also
want to look at the fixed/Auto report layout option that is in the
general report properties.
Jason
On 5/19/2010 6:03 AM, pigargo@gmx.at wrote:
> Hello,
>
> I have a problem with the image in my report. Because I'd like to set
> the size of "size-to-image". In the Bug 212502 I've seen that there was
> a problem in the version 2.3.0 which should be solve for version 2.5.0.
> Now I use BIRT 2.5.2 and I can't found the size in the advanced properties.
>
> Please can anyone say me, if there was still a problem or how I will
> define the scale of an image.
>
> Thanks for your help and excuse my confused english, but this forum
> seems better than the german one.
>
> pigargo
|
|
|
|
Re: image size in Birt 2.5.2 [message #535232 is a reply to message #535058] |
Fri, 21 May 2010 16:24 |
|
Any chance you could make a report with just your image and the cell and
send it to me at jasonweathersby at windstream dot net?
On 5/21/2010 4:07 AM, pigargo wrote:
> Hallo Jason,
>
> I have tried to set the parameter fit to container and also the general
> layout (fix, auto) parameter, but there were no differenc in my PDF.
> My image is set in a cell of a table and the image is always stretched
> to the size of my cell. It makes no matter in which combination.
>
> I'd like to print the original size of my image and if it will be bigger
> then the width of my cell it has to scale down to the width of my cell
> and the high has to scale down, so that my image is not distorted.
>
> Is this possible in Birt?
>
> Thank's for your help.
>
> pigargo
|
|
|
|
Powered by
FUDForum. Page generated in 0.03674 seconds