|Keep Bendpoint position on Connection-End Movement [message #527192]
||Wed, 14 April 2010 12:21
| Thomas Beyer
Registered: July 2009
currently, the relative bendpoints of the connections are implemented -
es their names indicate: relatively to its connection source and target
(with a weight).
Even though I think I sort of understood the way how bendpoints are
calculated and drawn via the connection routers, I could not find a
solution that would make my bendpoints sticky to their position when
either source or target node of the connection is moved, unless they are
explicitely dragged resp. moved.
Any help or suggestions is very much appreciated.
TIA & regards
Powered by FUDForum
. Page generated in 0.02171 seconds