Eclipse Community Forums: Eclipse Sumo » Waiting time in milliseconds or seconds?

Help

Home

Home » Proposals » Eclipse Sumo » Waiting time in milliseconds or seconds?(Waiting time in Sumo output units)

Show: Today's Messages :: Show Polls :: Message Navigator

Waiting time in milliseconds or seconds? [message #1859626]

Tue, 20 June 2023 17:48

Tomas Rodriguez

Messages: 2
Registered: June 2023

Junior Member

Hi,

I was running a simulation in SUMO for a university project where we are required to determine the service levels using the waiting time. However, the numbers the program outputs are in the thousands. If these were milliseconds this would make sense. Does anyone know if the waiting time units is is milliseconds or in seconds?

Thanks!

Report message to a moderator

Re: Waiting time in milliseconds or seconds? [message #1859675 is a reply to message #1859626]

Thu, 22 June 2023 08:17

Kabiru Usman

Messages: 42
Registered: April 2023

Member

You're on the right track! In SUMO, the time unit is indeed in milliseconds. So, if you're seeing waiting time values in the thousands, they're representing seconds. To convert them to seconds, simply divide by 1000. It's a common point of confusion, so don't worry, you're not alone in wondering about this.

Good luck with your university project!

Report message to a moderator