|
Re: Transition from LA to PA [message #1833092 is a reply to message #1833037] |
Fri, 02 October 2020 07:12 |
Pierre B Messages: 18 Registered: July 2020 |
Junior Member |
|
|
Hi Luc,
First of all I have 2 questions : how do you perform the transition and what version of Capella are you using ? Because on my side, when I'm performing a transition of logical components to physical components, they become behaviors by default. But I am using Capella 1.3.2, so maybe it has been changed in 1.4.
Then, to allocate behaviors to nodes it should be way easier. Normally you just have to insert a node in a diagram, then select "Manage behavior PCs deplyoement" in the palette on the right side, left click on your node and select the behavior you want to allocate to it. It should automatically insert the behavior into the node. Did you try that way ?
Hope this helps
[Updated on: Fri, 02 October 2020 07:13] Report message to a moderator
|
|
|
Re: Transition from LA to PA [message #1833098 is a reply to message #1833092] |
Fri, 02 October 2020 08:02 |
Luc Baldwin Messages: 10 Registered: August 2020 |
Junior Member |
|
|
Hello Pierre,
Thank you for your response,
I am using Capella 1.4.1, I performed the transition by right clicking the elements I wanted to transition in the project explorer > transitions > LC/LA to PC/PA.
When transitioning leaf logical components they become Behaviors but root components become node.
Yes I discovered this way of allocating behaviors to nodes while looking for a solution to my problem, but the issue is still there. I don't see the transitioned components in the tool, only the ones I have created in PA.
For the moment I have started to perform the "transition" manually, but if I could avoid doing it in the future I would quite enjoy it.
[Updated on: Fri, 02 October 2020 08:03] Report message to a moderator
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03399 seconds