Hex file created but not working [message #1815341] |
Tue, 01 October 2019 06:26 |
Vishakha Dakhane Messages: 4 Registered: September 2019 |
Junior Member |
|
|
Hello I am using Eclipse IDE for ARM development. I am using LPC1769 controller. I am able to build my project in eclipse , I don't get any errors and warnings after compiling the project. .hex file is also created. After flashing the program my pin doesn't toggle.I am using flash magic to flash the hex file. I tried the same code in Keil to check if there are hardware issues but it was working fine , the pin got toggled. I am completely stuck i don't understand what is the exact problem. If there were path related issues then I couldn't even build the code, it would have shown me errors regarding paths. But in this case i am not understanding how to solve this problem. Kindly help me!
|
|
|
Powered by
FUDForum. Page generated in 0.03330 seconds