|Re: Result after running Executable [message #1809907 is a reply to message #1809858]
||Thu, 25 July 2019 13:57
| Jeno Attila Balasko
Registered: September 2013
Location: Budapest, Hungary
your test.exe was compiled in single mode, thus it could run simple. But its output is strange. A typical single mode titan executable produces an output like this:
TTCN-3 Test Executor (single mode), version CRL 113 200/6 R6A
Execution of control part in module IntX started.
Test case tc_intx_unsigned started.
Test case tc_intx_unsigned finished. Verdict: pass
Test case tc_intx_signed started.
Test case tc_intx_signed finished. Verdict: pass
Test case tc_intx_2scompl started.
Test case tc_intx_2scompl finished. Verdict: pass
Test case tc_intx_record_of started.
Test case tc_intx_record_of finished. Verdict: pass
Test case tc_intx_record started.
Warning: f_dec_intx_rec_part(): Data remained at the end of the stream after successful decoding: 'A0'O
Test case tc_intx_record finished. Verdict: pass
Test case tc_intx_decode_error started.
Test case tc_intx_decode_error finished. Verdict: pass
Execution of control part in module IntX finished.
Verdict statistics: 0 none (0.00 %), 6 pass (100.00 %), 0 inconc (0.00 %), 0 fail (0.00 %), 0 error (0.00 %).
Test execution summary: 6 test cases were executed. Overall verdict: pass
Your demo.exe was compiled in parallel mode. It can be run this way (see UserGuide.pdf/Chapter 4.4):
ttcn3_start demo your.cfg
(If you had installed "expect")
If you don't have expect, the more complicated method should be folllowed according to 4.4
Jeno Balasko, Titan Team, Ericsson
Powered by FUDForum
. Page generated in 0.02488 seconds