Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » Ternary connector in component diagram(Can UML connector have more than 2 ends?)
Ternary connector in component diagram [message #1803158] Sun, 24 February 2019 00:14 Go to next message
Nikola Ruzic is currently offline Nikola RuzicFriend
Messages: 1
Registered: February 2019
Junior Member
Hi!

I'm trying to model complex connector between 3 component instances in papyrus component diagram.

Is it possible to do something like that with just connector element. I know I can model complex connector using components but this is not the point here. I want to connect more than two components with just one connector.

I noticed that In "model explorer" view I can add as many "connector ends" as child nodes to "connector" element. But this is not shown in diagrams. Basically you can't use such connector in diagrams.

Regards,
Nikola
Re: Ternary connector in component diagram [message #1803379 is a reply to message #1803158] Wed, 27 February 2019 14:55 Go to previous message
Camille Letavernier is currently offline Camille LetavernierFriend
Messages: 913
Registered: February 2011
Senior Member
Hi Nikola,

UML might allow that (Similar to N-ary association), but I don't think this has ever been supported in Papyrus diagrams

HTH,
Camille


Camille Letavernier
Previous Topic:Default Value and Code Generation
Next Topic:Need to run JUnit plug-in test with no GUI
Goto Forum:
  


Current Time: Thu Dec 12 00:11:01 GMT 2019

Powered by FUDForum. Page generated in 0.01539 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top