Eclipse Community Forums: ATL » ATL EMFTVM no entries available when trying to select module from workspace

Help

Home

Home » Modeling » ATL » ATL EMFTVM no entries available when trying to select module from workspace

Show: Today's Messages :: Show Polls :: Message Navigator

ATL EMFTVM no entries available when trying to select module from workspace [message #1795676]

Wed, 26 September 2018 16:31

omar hassane

Messages: 12
Registered: February 2018

Junior Member

Hi ,

I was trying to use ATL EMFTVM to launch a HOT transformation. But in the Run configuration dialog when I try to select the ATL module from workspace, it just shows "No entries available" , as seen in the attached picture.

index.php/fa/33955/0/

Thank you.

Attachment: runconfig.PNG
(Size: 52.10KB, Downloaded 547 times)

Report message to a moderator

Re: ATL EMFTVM no entries available when trying to select module from workspace [message #1795751 is a reply to message #1795676]

Thu, 27 September 2018 20:11

omar hassane

Messages: 12
Registered: February 2018

Junior Member

Hi,

I figured out the problem. It was just because of a bad installation of ATL on my eclipse. I reinstalled ATL again and I'm able to see and select the EMFTVM modules from the workspace.

Thank you

Report message to a moderator

Previous Topic:	Main thread of debugging terminated immediately
Next Topic:	BPMN to UPPAAL: problem with the target generated model

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Wed Apr 24 23:38:32 GMT 2024

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter