Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Language IDEs » C / C++ IDE (CDT) » Profiling with Gprof(How to)
Profiling with Gprof [message #1786419] Thu, 03 May 2018 05:57
Bo Eugen Gyring is currently offline Bo Eugen GyringFriend
Messages: 1
Registered: May 2018
Junior Member

I have been searching the Internet for help how to do profiling with Gprof but it never really applies to my current setup.

I am using Eclipse IDE for C/C++ Developers, Version: Oxygen.2 Release (4.7.2) and on top of that I am using Eclipse C++ IDE for Arduino 3.0 developed by Doug Schaefer I believe.

To give you some additional information, I have for the project in properties, selected Gprof as this image shows:


... then right clicking the project I select Profiling Tools -> 3. Profile Timing option. The outcome is an error shown here:


I have also tried to use the top menu Run and from here choose Profile Configurations and then created a new configuration with these options:


... where outcome is the same as


Does someone have an updated description of how to use Gprof or Perf for that matter I do not really have any preferences, if only it works :)


[Updated on: Mon, 07 May 2018 11:11]

Report message to a moderator

Previous Topic:CDT Plugin-in Development
Next Topic:Unusually complicated Content Assist
Goto Forum:

Current Time: Thu Nov 15 07:00:05 GMT 2018

Powered by FUDForum. Page generated in 0.02771 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top