Eclipse Community Forums: Kura » MQTT message not writing to asset

Help

Home

Home » Eclipse Projects » Kura » MQTT message not writing to asset

Show: Today's Messages :: Show Polls :: Message Navigator

MQTT message not writing to asset [message #1782860]

Fri, 02 March 2018 15:42

Alessandro Tagliapietra

Messages: 2
Registered: March 2018

Junior Member

In the wires section we've setup a subscribe that's connected to an asset and a logger.

When I send a json like `{metrics:{var: value}}`in /var/log/kura.log I see the logger outputs the WireEnvelope with my metrics but even if the asset has the variable with the same name in READ_WRITE or WRITE it doesn't change.

If I connect the asset to the logger as well and the variable is in READ_WRITE mode it outputs another WireEnvelope with the same variable with the unchanged value.

Is there anything wrong with the request?

Report message to a moderator

Re: MQTT message not writing to asset [message #1783393 is a reply to message #1782860]

Mon, 12 March 2018 15:00

Matteo Maiero

Messages: 260
Registered: July 2015
Location: Italy

Senior Member

Does the type match?

If I'm not wrong, both the name and the type are compared when a value needs to be written to an asset.

Best regards,
Matteo

Report message to a moderator

Re: MQTT message not writing to asset [message #1783396 is a reply to message #1783393]

Mon, 12 March 2018 15:21

Alessandro Tagliapietra

Messages: 2
Registered: March 2018

Junior Member

Matteo Maiero wrote on Mon, 12 March 2018 15:00

Does the type match?

If I'm not wrong, both the name and the type are compared when a value needs to be written to an asset.

It should, it was set to float and I was sending a decimal via JSON, is there an example somewhere just to test the same values/types as the example?

Report message to a moderator

Re: MQTT message not writing to asset [message #1783535 is a reply to message #1783396]

Tue, 13 March 2018 20:24

Matteo Maiero

Messages: 260
Registered: July 2015
Location: Italy

Senior Member

Which example are you referring to?
It could be that the Typed value of the value returned by the subscriber do not match the one expected by your asset.
If possible, I would suggest to have a try first with the Kura Payload and see if it works as expected.
Best regards,
Matteo

Report message to a moderator