Post-Build uses /usr/bin/sh instead of cmd under Windows [message #1736451] |
Wed, 29 June 2016 12:53 |
Roland Caßebohm Messages: 1 Registered: June 2016 |
Junior Member |
|
|
Hello!
I have the following problem:
I want to start a BAT-File after build. Therefore I have set
..\post_compiler.bat "${BuildArtifactFileBaseName}"
under Settings -> Build Steps -> Post-build Steps -> Command
This works fine to my colleagues, but not for me:
..\post_compiler.bat "dhem.project.cdc_252_acb.sw4stm32.stm32l0xx"
/usr/bin/sh: ..post_compiler.bat: command not found
It seems that something ist wrong with my enviroment. If I change \ to / it works for me, but not for my colleague. In my enviroment /usr/bin/sh is called and in the others cmd?
I kwow one difference: I have installed a Cygwin but my colleagues not.
Does anybody have any idea what could I do, to have the same results like my colleagues?
Many thanks in advance,
Roland
|
|
|
Powered by
FUDForum. Page generated in 0.01967 seconds