|Inhereting the ports of a block from its IBD [message #1733412]
||Fri, 27 May 2016 02:57
| Jules Franc
Registered: May 2016
I have a block A. I made an IBD with flow ports on its boundaries.
I made a new BDD where another block B is composed of A.
I am now making the IBD of B. It shows the block A inside B.
However, it does not show the ports I defined in the IBD of A.
Is it possible ? Or do I have to create all the ports of A again in the IBD of B ?
How to avoid inconsistencies between the ports of A shown in its own IBD, and the ports of A shown in the IBD of B ?
Thank you very much !
IBD = Internal Block Diagram
BDD = Block Definition Diagram
Powered by FUDForum
. Page generated in 0.01689 seconds