|[Acceleo] Run my generator code from CLI [message #1701264]
||Fri, 10 July 2015 11:04
| bilel feddaoui
Registered: May 2015
I created my generator code using Acceleo ,the data model using Papyrus.
My generator code contains many files .mtl , In the beginning I ran those files one by one using right click on file.mtl and "launch acceleo application" inside of Eclipse after selecting data model file and output folder.
After that I learned how to use wizard Acceleo to create project.ui and I can run my code generator with one click , but I need another way to run my code generator outside of eclipse from shell Command line interface (wihtout eclipse).
How can I do that ?
Thank you very much.
[Updated on: Fri, 10 July 2015 11:05]
Report message to a moderator
Powered by FUDForum
. Page generated in 0.01839 seconds