Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » ATL » problem in running of ATL module (ATL)
problem in running of ATL module [message #1691294] Sat, 04 April 2015 21:19
FSM ISFSM is currently offline FSM ISFSMFriend
Messages: 21
Registered: March 2015
Junior Member
Hi,
I am currently developing an ATL module to transform the SysML language to Acme
Here is the ATL module:
    module Verification;
    create OUT : MetaAcme from IN : MetaSysml;
     
     
     
     rule Bddiagram2Family {
    	from  s: MetaSysml!BDDiagram
    	to  
    	     t : MetaAcme!Family ( 
    		    name        <- s.name 		
    	), 
    	t1 : MetaAcme!System ( 
     name     <- 'System' ,
    connector<-s.compflow->collect(b|thisModule.Connector(b) )
     
     
    			)}
     
     lazy  rule  Connector
     {
     	from  s:MetaSysml!ItemFlow
     
    	to     t:MetaAcme!Connector(name<-s.name)
     }


The problem that arises here is that the output contains only System and Family, he was there no connector under System.
As shown in the following figure:
index.php/fa/21439/0/

Anyone can help me to resolve this problem
Thank you very much.
  • Attachment: SysML.png
    (Size: 4.08KB, Downloaded 271 times)
Previous Topic:Inter-model references problem
Next Topic:Automated runs of ATL-Transformations
Goto Forum:
  


Current Time: Sun Nov 19 20:00:19 GMT 2017

Powered by FUDForum. Page generated in 0.01263 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software