Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » UML Testing Profile(Import a xmi profile)
UML Testing Profile [message #1060288] Thu, 23 May 2013 22:08 Go to next message
Joe I is currently offline Joe IFriend
Messages: 28
Registered: May 2013
Junior Member
Hello,

I'd like to use the testing profile from omg.org/spec/UTP/1.2/ .
But I couldn't figure it out how to import a .xmi file (also changing to .uml doesn't work).

So does anyone know how to do that?
Thanks!
Re: UML Testing Profile [message #1060302 is a reply to message #1060288] Fri, 24 May 2013 05:02 Go to previous messageGo to next message
Ed Willink is currently offline Ed WillinkFriend
Messages: 4150
Registered: July 2009
Senior Member
Hi

IIRC there was some traffic on the UML newsgroup (but perhaps here)
about UTP.

Regards

Ed Willink

On 24/05/2013 03:03, Joe I wrote:
> Hello,
>
> I'd like to use the testing profile from omg.org/spec/UTP/1.2/ .
> But I couldn't figure it out how to import a .xmi file (also changing
> to .uml doesn't work).
>
> So does anyone know how to do that?
> Thanks!
Re: UML Testing Profile [message #1060310 is a reply to message #1060302] Fri, 24 May 2013 06:40 Go to previous message
Federico Toledo is currently offline Federico ToledoFriend
Messages: 97
Registered: April 2012
Location: Ciudad Real, Spain
Member
I had this problem trying to use UML-TP 1.1, and I solved it (with Ed Willink's help) adjusting some URIs


I had to change this:

http://www.omg.org/spec/UML/20090901

for this

http://schema.omg.org/spec/UML/2.2


And now I am using the profile with no problem

Good luck!
Previous Topic:Question about palette
Next Topic:Qualified Associations
Goto Forum:
  


Current Time: Sun Nov 23 07:29:44 GMT 2014

Powered by FUDForum. Page generated in 0.03580 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software