Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Language IDEs » C / C++ IDE (CDT) » C++ Windows - cannot step after breakpoint
C++ Windows - cannot step after breakpoint [message #990338] Tue, 11 December 2012 23:19
Eclipse UserFriend
Windows XP and mingw, C++:

When I 'debug', the program breaks at main(). I can then step over or
step into, and it displays variables. All is well.

However, if I set a breakpoint, when the program breaks, I can't step or
resume. The buttons and menus are greyed out, disabled.

The console displays this.

Previous Topic:Autotools-generated make targets not shown in 'Make targets' view
Next Topic:GDB: No symbol table is loaded. Use the "file" command.
Goto Forum:

Current Time: Sun Oct 23 14:27:03 GMT 2016

Powered by FUDForum. Page generated in 0.04337 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software